Ebode RPL User's Guide download pdf (Page 7)

Receiver - Plug-In Dimmer Module Ref : RPL

July 2009 page 7 RPL

To reset all lamp module addresses

1. Use a small sharp object, e.g. a paper clip, to press and hold the

setup button until the green led turns on. (about 3 or 4 seconds)

2. Release the button, the led will blink red and green and then

turn off.

3. When the red and green LEDs are off, the module is reset.

Tips - Knowledge base available on www.ebodeelectronics.eu.

Can I plug RPL module into a power strip?

This is no problem with a simple power strip however you can not use the module

with a surge protected power strip.

Operating the RPL Module

I’m using a X10 compatible wireless remote, e.g. TPC, IMRF, EM, SS13,

KR22, SH600 or HR10, but the RPL is not responding?

- Check and/or change remote control batteries.

- Check if your transceiver is correctly connected.

RF Transmitter = RPT, RMA, RMV, TM13, CM15 or SC28 security console

IR Transmitter = IR7243 along with the remote control

- Reset the RPL (see paragraph 3) then reprogram the address.

- Then, proceed again using learning mode as explained in 2.)

The RPT does not respond to command sent via the power line?

- Reset the RPL (see paragraph 3) then initialize the address.

- Then, proceed again using learning mode as explained in 2.

Functions enabled by a wireless transmitter (EM, TPC, IMRF, etc..)

ON / OFF key

Turns the lamp On & Off

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

No comments

Ebode RPL User's Guide Page 7