Ebode RPL User's Guide download pdf (Page 6)

Receiver - Plug-In Dimmer Module Ref : RPL

July 2009 page 6 RPL

1. Plug the lamp into

the module.

2. Plug the module

into a socket.

Installing the lamp module

NOTE:

- Make sure not to plug an appliance into the RPL.

- Make sure the light is powered on.

X10 address

The X10 address consists of a House Code and a Unit Code.

In order for this module to respond to a command sent via the

Power line, the module needs to be initialized. It is possible to

congure multiple addresses for this module.

Programming the RPL module

If you want to control the RPL via a RF remote like the ebode TPC,

EM or IMRF, you need to install a RF transceiver (e.g. RPT, TM13,

CM15 or SC28 security console).

1. Use a small pointed object, e.g. a paper clip, to shortly press the

setup button. This button is situated in the small opening between

the two LEDs. When the button is pressed, the green LED will blink

quickly, waiting for a command.

2. Send the ‘power on’ command for the desired address.

3. The LED will stop blinking.

4. The lamp module address is now stored.

5. If you wish to congure additional addresses repeat this procedure

from step 1.

General information

- The RPL Lamp module can be congured to respond to up to 32 X10

addresses.

- The led will blink red when ON/OFF commands are received.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Ebode RPL User's Guide Page 6