Ebode RMV User's Guide download pdf (Page 6)

Receiver - Wall-Mounted Shutter Module Ref : RMV

July 2009 page 6 RMV

Schematic 1

To connect the in-wall switch.

CONNECTING BLOCK

To learn one address on wall switch (unique

addressable control)

An address is made of a HOUSE code and UNIT code, please refer

to the manual of the transmitter to properly x the code to learn

by the receiver.

The following procedure consists of learning one (or even more

than one) address from the transmitter into the receiver RMV.

Please bear in mind to shut off general mains in the electrical panel.

Connect all wires as indicated (refer to wiring

diagram 1)

L : stands for input Live 230V - 50 Hz

N : stands for input Neutral 230V - 50Hz

How to connect Live + Neutral Input

N : Neutral

Wiring up Live +

Neutral outputs

LIVE DOWN output to

Motorization

C : Never connect C : only for low voltage

How to install wall mount switch.

Wall insert box : dia. 65mm, 40mm deep

1.Gently take off paddle from wall switch.

2.Wire up Wall Switch within wall insert box, then x receiver

along with provided screws again wall insert box.

Please note that the general mains in the electrical panel

should be turned on again before you start programming.

Ph N

LIVE UP output to

Motorization

1 2 3 4 5 6 7 8 9 10 11 ... 31 32

No comments

Ebode RMV User's Guide Page 6